Honda CR-V: VSA (Vehicle Stability Assist) System Components
Honda CR-V (2006–2011) Service Manual / Brakes / VSA (Vehicle Stability Assist) System Components
Component Location Index
- VSA MODULATOR-CONTROL UNIT
- Removal and Installation
- UNDER-HOOD FUSE/RELAY BOX
- DATA LINK CONNECTOR (DLC)
- STEERING ANGLE SENSOR
- Replacement
- VSA OFF SWITCH
- Test
- RIGHT-REAR WHEEL SENSOR
- Replacement
- HUB BEARING UNIT
(MAGNETIC ENCODER)
- Replacement
- LEFT-REAR WHEEL SENSOR
- Replacement
- HUB BEARING UNIT
(MAGNETIC ENCODER)
- Replacement
- UNDER-DASH FUSE/RELAY BOX
- LEFT-FRONT WHEEL SENSOR
- Replacement
- WHEEL BEARING
(MAGNETIC ENCODER)
- Replacement
- YAW RATE-LATERAL
ACCELERATION SENSOR
- Replacement
- RIGHT-FRONT WHEEL SENSOR
- Replacement
- WHEEL BEARING
(MAGNETIC ENCODER)
- Replacement
- General Troubleshooting Information
- System Description
- DTC Troubleshooting
- Symptom Troubleshooting
- Steering Angle Sensor Replacement
READ NEXT:
General Troubleshooting Information
System Indicator
This system has four indicators:
ABS indicator (A)
Brake system indicator (B)
VSA indicator (C)
VSA activation indicator (D)
When the system detects a problem, it will turn the
System Description
VSA Modulator-control Unit Inputs and Outputs for 46P Connector
System Outline
This system is composed of the VSA modulator-control unit, the wheel sensors,
the steering angle sensor, and the
yaw
SEE MORE:
Receiving XM Radio Service
If your XM Radio service has expired
or you purchased your vehicle from
a previous owner, you can listen to a
sampling of the broadcasts available
on XM Radio. With the ignition
switch in the ACCESSORY (I) or ON
(II) position, push the
button to
turn on the audio system and press
t
Hood
Hood Adjustment
1. Remove these items:
Front bulkhead cover
Front fender trim
Cowl cover
2. Slightly loosen each bolt (A).
3. Adjust the hood alignment in this sequence:
Adjust the hood right and left, as well as forward and rearward, by
using the elongated holes in the hood
hinges (B).
© 2016-2025 Copyright www.hcrv.net
