Honda CR-V: PGM-FI System
Component Location Index

-
CAMSHAFT POSITION (CMP)
SENSOR B (EXHAUST)
-
OUTPUT SHAFT (COUNTERSHAFT)
SPEED SENSOR
-
POWERTRAIN CONTROL
MODULE (PCM)
-
ELECTRICAL LOAD
DETECTOR (ELD)
(bottom of fuse/relay box)
-
A/F SENSOR
(LAF) RELAY
(RELAY SOCKET E)
-
IGNITION
COIL RELAY
(RELAY SOCKET B)
-
MASS AIR FLOW (MAF) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR
-
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 1
-
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 2
-
MANIFOLD ABSOLUTE
PRESSURE (MAP) SENSOR
-
KNOCK SENSOR
-
INJECTORS
-
CRANKSHAFT POSITION
(CKP) SENSOR
-
IGNITION
COIL

READ NEXT:
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the sa
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Check for poor connections or loose terminals at
ECT sensor 1/2
SEE MORE:
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If a high voltage battery (24 V, etc.) is connected to
the vehicle, this DTC can be stored.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
1. Make sure the battery connections are good and
the battery is sufficiently charged.
2. Connect a VAT-40 (or equivalent tester), and turn
the selector switch to position 1 (starting).
3. Start the engine. Hold the engine speed at
3,000 rpm with no load until the radiator fan comes
on, then let i
© 2016-2025 Copyright www.hcrv.net
