Honda CR-V: Idle Control System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Idle Control System
Component Location Index
- POWER STEERING PRESSURE (PSP) SWITCH
- Signal Circuit Troubleshooting
- A/C COMPRESSOR
CLUTCH RELAY
(RELAY SOCKET A)
- Signal Circuit Troubleshooting
- POWERTRAIN CONTROL
MODULE (PCM)
- General Troubleshooting Information
- Replacement
- A/C COMPRESSOR
- ALTERNATOR
- Signal Circuit Troubleshooting
- A/C PRESSURE SENSOR
- BRAKE PEDAL POSITION SWITCH
- Signal Circuit Troubleshooting
- DTC Troubleshooting
- A/C Signal Circuit Troubleshooting
- PSP Switch Signal Circuit Troubleshooting
- Brake Pedal Position Switch Signal Circuit Troubleshooting
READ NEXT:
DTC Troubleshooting
DTC P0506: Idle Control System RPM Lower
Than Expected
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the
A/C Signal Circuit Troubleshooting
1. Start the engine, and let it idle.
2. Turn the blower switch on.
3. Turn the A/C switch on.
4. Check the A/C CLUTCH in the DATA LIST with the
HDS.
Does it indicate ON?
YES-Go to step 5.
5. Check t
PSP Switch Signal Circuit Troubleshooting
1. Start the engine, and let it idle.
2. Align the steering wheel straight ahead.
3. Check the PSP SWITCH in the DATA LIST with the
HDS.
Does it indicate ON?
YES-Go to step 4.
NO-Go to step 14.
4.
SEE MORE:
VTEC/VTC
Component Location Index
ROCKER ARM OIL CONTROL VALVE
Removal/Installation
ROCKER ARM OIL PRESSURE SWITCH
Removal/Installation
CAMSHAFT POSITION (CMP) SENSOR A (INTAKE)
Replacement
POWERTRAIN CONTROL
MODULE (PCM)
Gene
Evaporator Core
Replacement
1. Recover the refrigerant with a recovery/recycling/ charging station.
2. Remove the bolt from the A/C line clamp, and
remove the receiver line (A) from the clips (B).
3. Remove the nut, then disconnect the A/C lines (A)
from the evaporator core.
4. Remove the stud bolt.
5. Remove the blower un
© 2016-2025 Copyright www.hcrv.net
