Honda CR-V: PGM-FI System
Component Location Index

-
CAMSHAFT POSITION (CMP)
SENSOR B (EXHAUST)
-
OUTPUT SHAFT (COUNTERSHAFT)
SPEED SENSOR
-
POWERTRAIN CONTROL
MODULE (PCM)
-
ELECTRICAL LOAD
DETECTOR (ELD)
(bottom of fuse/relay box)
-
A/F SENSOR
(LAF) RELAY
(RELAY SOCKET E)
-
IGNITION
COIL RELAY
(RELAY SOCKET B)
-
MASS AIR FLOW (MAF) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR
-
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 1
-
ENGINE COOLANT TEMPERATURE
(ECT) SENSOR 2
-
MANIFOLD ABSOLUTE
PRESSURE (MAP) SENSOR
-
KNOCK SENSOR
-
INJECTORS
-
CRANKSHAFT POSITION
(CKP) SENSOR
-
IGNITION
COIL

READ NEXT:
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the sa
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Check for poor connections or loose terminals at
ECT sensor 1/2
SEE MORE:
Testing of Readiness Codes
If you take your vehicle for an
emissions test shortly after the
battery has been disconnected or
gone dead, it may not pass the test.
This is because of certain ‘‘readiness
codes’’ that must be set in the onboard
diagnostics for the emissions
systems
NOTE: Before doing this troubleshooting procedure,
review SRS Precautions and Procedures.
1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on, and is DTC 71-2x
indicated?
YES-G
© 2016-2025 Copyright www.hcrv.net
