Honda CR-V: Engine Assembly
Honda CR-V (2006–2011) Service Manual / Engine Mechanical / Engine Assembly
- Engine Removal
- Engine Installation
- Side Engine Mount Replacement
- Transmission Mount Replacement
- Side Engine Mount Bracket Replacement
READ NEXT:
Engine Removal
Universal eyelet 07AAK-SNAA120
Engine hanger adapter VSB02C000015 *
Front subframe adapter VSB02C000016 *
CR-V engine hanger adapter VSB02C000032 *
Engine support hanger, A and Reds AAR-T-12566
Engine Installation
Special Tools Required
Universal eyelet 07 AAK-SNAA 120
Engine hanger adapter VSB02C000015 *
Front subframe adapter VSB02C000016 *
CR-V engine hanger adapter VSB02C000032 *
Engine support hanger
Side Engine Mount Replacement
1. Support the engine with a jack and wood block
under the oil pan.
2. Remove the power steering (P/S) fluid reservoir
from the holder.
3. Remove the upper torque rod.
4. Remove the ground cable (A
SEE MORE:
Front Driveshaft Installation
1. Apply grease to the contact area (A) of the outboard
joint and front wheel bearing.
NOTE: Failure to apply grease may cause excessive
noise and vibration.
2. Install a new set ring (A) onto the set ring groove
(B) of the driveshaft (left driveshaft).
3. Apply 0.5-1.0 g (0.02-0.04 oz) of grease
Shift Solenoid Valve
Shift Solenoid Valve Test
1. Connect the HDS to the DLC (A).
2. Choose Shift Solenoid A, B, C, D, and E in the
Miscellaneous Test Menu on the HDS.
NOTE: If the HDS does not communicate with the
PCM, troubleshoot the DLC circuit.
3. Check that shift solenoid valves A, B, C, D, and E
operate with t
© 2016-2025 Copyright www.hcrv.net
