Honda CR-V: Cooling System
Honda CR-V (2006–2011) Service Manual / Engine Cooling / Cooling System
Component Location Index
-
COOLANT SEPARATOR
-
EXHAUST GAS RECIRCULATION (EGR) PASSAGE
-
THERMOSTAT
-
RADIATOR
-
ENGINE COOLANT TEMPERATURE (ECT) SENSOR 2
-
RADIATOR FAN ASSEMBLY
-
A/C CONDENSER FAN ASSEMBLY
-
WATER PUMP
-
WATER PASSAGE
- Radiator Cap Test
- Water Passage Replacement
- EGR Passage Removal and Installation
- Fan, Fan Motor, Shroud Removal and Installation
- Radiator Replacement
READ NEXT:
Radiator Cap Test
1. Remove the radiator cap (A), wet the seal with
engine coolant, then install it on the pressure tester
(B) (commercially available).
2. Apply a pressure of 93-123 kPa
(0.95-1.25 kgf/cm2, 14-18 psi)
Water Passage Replacement
1. Drain the engine coolant.
2. Remove the alternator.
3. Remove the condenser fan shroud assembly.
4. Remove the A/C compressor without disconnecting
the A/C hoses (see step 34).
5. Remove the in
EGR Passage Removal and Installation
Removal
1. Drain the engine coolant.
2. Remove the air cleaner housing.
3. Remove the harness holder (A) from the bracket,
then remove the harness holder bracket (B).
4. Remove the upper radiator h
SEE MORE:
Damper/Spring
Damper/Spring Removal and Installation
Removal
1. Raise the rear of the vehicle, and support it with safety stands in the
proper locations.
2. Remove the rear wheel.
3. Remove the lid (A) on the cargo area side trim
panel by releasing the hooks (B).
4. Remove the flange nuts (C) from the top o
Engine Compression Inspection
NOTE: After this inspection, you must reset the
powertrain control module (PCM), otherwise the PCM
will continue to stop the injectors from functioning.
Select PCM reset using the Honda Diagnostic System
(HDS).
1. Warm up the engine to normal operating
temperature (cooling fan comes on).
2. Turn t
© 2016-2025 Copyright www.hcrv.net
