Honda CR-V: Cooling System

Component Location Index

Honda CR-V. Cooling System

READ NEXT:

 Radiator Cap Test

1. Remove the radiator cap (A), wet the seal with engine coolant, then install it on the pressure tester (B) (commercially available). 2. Apply a pressure of 93-123 kPa (0.95-1.25 kgf/cm2, 14-18 psi)

 Water Passage Replacement

1. Drain the engine coolant. 2. Remove the alternator. 3. Remove the condenser fan shroud assembly. 4. Remove the A/C compressor without disconnecting the A/C hoses (see step 34). 5. Remove the in

 EGR Passage Removal and Installation

Removal 1. Drain the engine coolant. 2. Remove the air cleaner housing. 3. Remove the harness holder (A) from the bracket, then remove the harness holder bracket (B). 4. Remove the upper radiator h

SEE MORE:

 Power switch will not turn ON (No information display and no sound) (with navigation)

1. With the ignition switch ON (II), push the power switch ON to see if navigation unit turns ON. Does the navigation unit display operate properly, and does the audio sound normal? YES-Intermittent failure, the system is OK at this time. NO-Go to step 2. 2. Turn the ignition switch OFF. 3. Che

 Interior Lights

Component Location Index With moon roof INDIVIDUAL MAP LIGHTS INTERIOR LIGHT SWITCH (Built into the moonroof switch) AMBIENT LIGHT (Built into the moonroof switch) CEILING LIGHT CARGO AREA LIGHT RIGHT REAR DOOR SWITCH TAILGATE LATCH SWITCH LEFT REAR DOOR SWITCH FRONT PASSENGER'S DOOR S

© 2016-2025 Copyright www.hcrv.net