Honda CR-V: TPMS (Tire Pressure Monitoring System)
Honda CR-V (2006–2011) Service Manual / Suspension / TPMS (Tire Pressure Monitoring System)
Component Location Index
- TPMS CONTROL UNIT
(Behind the dashboard center lower cover)
- Replacement
- TIRE PRESSURE SENSOR
- Replacement
- TIRE PRESSURE SENSOR
- Replacement
- UNDER-DASH FUSE/RELAY BOX
- TIRE PRESSURE SENSOR
- Replacement
- DATA LINK CONNECTOR (DLC)
- TIRE PRESSURE SENSOR
- Replacement
- UNDER-HOOD FUSE/RELAY BOX
- General Troubleshooting Information
- Memorizing the Tire Pressure Sensor ID
- DTC Troubleshooting
- Symptom Troubleshooting
- Tire Pressure Sensor Replacement
READ NEXT:
General Troubleshooting Information
System Indicator locations
The system has two indicators.
The low pressure indicator (A)
The TPMS indicator (B)
How TPMS Works
The TPMS (tire pressure monitoring system) has a low
pressure indica
Memorizing the Tire Pressure Sensor ID
Special Tools Required
TPMS sensor initializer tool AKS0620006
Available through the American Honda Tool and
Equipment program, 888-424-6857.
All four tire pressure sensor IDs must be memorized to
th
DTC Troubleshooting
DTC 11, 13, 15, 17: Low Tire Pressure
NOTE: If low tire pressure is detected, the control unit
sets one or more of these DTCs, and turns on the low
pressure indicator. If the low pressure indicator co
SEE MORE:
Multiplex Integrated Control System
Component Location Index
GAUGE CONTROL MODULE
Input Test
Replacement
IMMOBILIZER-KEYLESS CONTROL UNIT
(Built in receiver)
MICU (Built into the under-dash fuse/relay box)
Input Test
Replacement
General Troubleshooting Information
Troubleshooting CAN Circuit Related Problems
NOT
Blower Unit
Removal/Installation
1. Remove the glove box.
2. Disconnect the connector (A), then remove the
connector clip (B), the wire harness clips (C), the
bolts, and the glove box frame (D).
3. Cut the plastic cross brace (A) in the glove box
opening with diagonal cutters in the area shown.
Retain plastic cross brace to be r
© 2016-2025 Copyright www.hcrv.net
