Honda CR-V: Dashboard

READ NEXT:

 Center Upper Dashboard Panel Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Use the appropr

 Driver's Vent Panel Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Use the appropr

 Passenger's Tray Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS compo

SEE MORE:

 Radiator Replacement

For Japan-produced Model 1. Drain the engine coolant. 2. Remove the hood support rod, then use it as shown to prop the hood in the wide-open position. 3. Remove the bulkhead cover. 4. Remove the coolant reservoir hose (A) and upper radiator hose (B). 5. Raise the vehicle on the lift to full heig

 MICU Input Test

1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A, and check the No.8 (10 A), No. 10 (7.5 A), and No. 38 (30 A) fuses in the under-dash fuse/relay box. 2. Disconnect under-dash fuse/relay box connectors E, F, S, and T. NOTE: All connector views are wire side of female termin

© 2016-2025 Copyright www.hcrv.net