Honda CR-V: Idle Control System
Component Location Index

- POWER STEERING PRESSURE (PSP) SWITCH
- Signal Circuit Troubleshooting
- A/C COMPRESSOR
CLUTCH RELAY
(RELAY SOCKET A)
- Signal Circuit Troubleshooting
- POWERTRAIN CONTROL
MODULE (PCM)
- General Troubleshooting Information
- Replacement
- A/C COMPRESSOR
- ALTERNATOR
- Signal Circuit Troubleshooting
- A/C PRESSURE SENSOR

- BRAKE PEDAL POSITION SWITCH
- Signal Circuit Troubleshooting
READ NEXT:
DTC P0506: Idle Control System RPM Lower
Than Expected
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the
1. Start the engine, and let it idle.
2. Turn the blower switch on.
3. Turn the A/C switch on.
4. Check the A/C CLUTCH in the DATA LIST with the
HDS.
Does it indicate ON?
YES-Go to step 5.
5. Check t
1. Start the engine, and let it idle.
2. Align the steering wheel straight ahead.
3. Check the PSP SWITCH in the DATA LIST with the
HDS.
Does it indicate ON?
YES-Go to step 4.
NO-Go to step 14.
4.
SEE MORE:
Component Location Index
CAMSHAFT POSITION (CMP)
SENSOR B (EXHAUST)
OUTPUT SHAFT (COUNTERSHAFT)
SPEED SENSOR
POWERTRAIN CONTROL
MODULE (PCM)
ELECTRICAL LOAD
DETECTOR (ELD)
(bottom of fuse/relay box)
A/F SENSOR
(LAF) RELAY
(RELAY SOCKET E)
IGNITION
CO
NOTE:
Check the radio reception in an open area.
Compare it to a known-good vehicle of the same
model, year, and trim level whenever possible.
If necessary, have the customer demonstrate the
symptom.
Poor reception/interference can be caused by the following.
The radio station is far away.
© 2016-2025 Copyright www.hcrv.net
