Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0443: EVAP Canister Purge Valve Circuit Malfunction

Special Tools Required Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A or equivalent, commercially available. NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and revie

 DTC P0451: FTP Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P2422 is stored at the same time as DTC P0451, trouble

 DTC P0453: FTP Sensor Circuit High Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the H

SEE MORE:

 Setting the Clock

On models without navigation system To set the time, press the CLOCK button until you hear a beep. The displayed time begins to blink. Change the hours by pressing the H (hour) button until the numbers advance to the desired time. Change the minutes by pressing the M (minute) button un

 Steering Column

Steering Column Removal and Installation SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. Removal NOTICE Be careful not to pull the bracket (A) on the front side of steering column out of its normal positi

© 2016-2025 Copyright www.hcrv.net