Honda CR-V: TPMS (Tire Pressure Monitoring System)
Honda CR-V (2006–2011) Service Manual / Suspension / TPMS (Tire Pressure Monitoring System)
Component Location Index
- TPMS CONTROL UNIT
(Behind the dashboard center lower cover)
- Replacement
- TIRE PRESSURE SENSOR
- Replacement
- TIRE PRESSURE SENSOR
- Replacement
- UNDER-DASH FUSE/RELAY BOX
- TIRE PRESSURE SENSOR
- Replacement
- DATA LINK CONNECTOR (DLC)
- TIRE PRESSURE SENSOR
- Replacement
- UNDER-HOOD FUSE/RELAY BOX
- General Troubleshooting Information
- Memorizing the Tire Pressure Sensor ID
- DTC Troubleshooting
- Symptom Troubleshooting
- Tire Pressure Sensor Replacement
READ NEXT:
General Troubleshooting Information
System Indicator locations
The system has two indicators.
The low pressure indicator (A)
The TPMS indicator (B)
How TPMS Works
The TPMS (tire pressure monitoring system) has a low
pressure indica
Memorizing the Tire Pressure Sensor ID
Special Tools Required
TPMS sensor initializer tool AKS0620006
Available through the American Honda Tool and
Equipment program, 888-424-6857.
All four tire pressure sensor IDs must be memorized to
th
DTC Troubleshooting
DTC 11, 13, 15, 17: Low Tire Pressure
NOTE: If low tire pressure is detected, the control unit
sets one or more of these DTCs, and turns on the low
pressure indicator. If the low pressure indicator co
SEE MORE:
Differential Disassembly
Special Tools Required
Holder handle 07JAB-001020A
Companion flange holder 07RAB-TB4010B
1. Remove the drain plug (A) and the oil filler plug (B)
with sealing washers (C).
2. Raise the locknut tab (A) from the groove of the
clutch guide, making sure the tab completely clears
the groove to preve
Transmission End Cover
End Cover Removal
Special Tools Required
Mainshaft holder 07GAB-PF50101 or 07GAB-PF50100
NOTE: The illustration shows the 4WD transmission; the 2WD is similar.
1. Remove the cooler inlet line bolt (D), sealing washers, and line bracket
bolts (E), and remove the ATF cooler inlet
line (F).
2. Remove
© 2016-2025 Copyright www.hcrv.net
