Honda CR-V manuals

Honda CR-V: Idle Control System

Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Idle Control System

Component Location Index

Honda CR-V. Component Location Index

Honda CR-V. Component Location Index

READ NEXT:

 DTC Troubleshooting

DTC P0506: Idle Control System RPM Lower Than Expected NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the

 A/C Signal Circuit Troubleshooting

1. Start the engine, and let it idle. 2. Turn the blower switch on. 3. Turn the A/C switch on. 4. Check the A/C CLUTCH in the DATA LIST with the HDS. Does it indicate ON? YES-Go to step 5. 5. Check t

 PSP Switch Signal Circuit Troubleshooting

1. Start the engine, and let it idle. 2. Align the steering wheel straight ahead. 3. Check the PSP SWITCH in the DATA LIST with the HDS. Does it indicate ON? YES-Go to step 4. NO-Go to step 14. 4.

SEE MORE:

 Piston Ring Replacement

1. Remove the piston from the engine block. 2. Using a ring expander (A), remove the old piston rings (B). 3. Clean all ring grooves thoroughly with a squared-off broken ring or ring groove cleaner with a blade to fit the piston grooves. The top and 2nd ring grooves are 1.2 mm (0.05 in.) wide. Th

 Side Airbag Replacement

NOTE: Review the seat replacement procedure before doing repairs or service. Removal 1. Disconnect the negative cable from the battery, and wait at least 3 minutes before beginning work. 2. Disconnect the side airbag harness 2P connector (A). 3. Remove the seat assembly and seat-back cover. 4. Re

© 2016-2025 Copyright www.hcrv.net