Honda CR-V: PGM-FI System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / PGM-FI System
Component Location Index
-
CAMSHAFT POSITION (CMP) SENSOR B (EXHAUST)
-
OUTPUT SHAFT (COUNTERSHAFT) SPEED SENSOR
-
POWERTRAIN CONTROL MODULE (PCM)
-
ELECTRICAL LOAD DETECTOR (ELD) (bottom of fuse/relay box)
-
A/F SENSOR (LAF) RELAY (RELAY SOCKET E)
-
IGNITION COIL RELAY (RELAY SOCKET B)
-
MASS AIR FLOW (MAF) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR
-
ENGINE COOLANT TEMPERATURE (ECT) SENSOR 1
-
ENGINE COOLANT TEMPERATURE (ECT) SENSOR 2
-
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR
-
KNOCK SENSOR
-
INJECTORS
-
CRANKSHAFT POSITION (CKP) SENSOR
-
IGNITION COIL
-
DATA LINK CONNECTOR (DLC)
-
PGM-FI MAIN RELAY 2 (FUEL PUMP)
- DTC Troubleshooting
- F-CAN Circuit Troubleshooting
- DLC Circuit Troubleshooting
- Injector Replacement
- PCM Replacement
READ NEXT:
DTC P0101: MAF Sensor Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the sa
DTC P0111: IAT Sensor Circuit Range/Performance Problem
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Check for poor connections or loose terminals at
ECT sensor 1/2
SEE MORE:
Tire Inspection
Every time you check inflation, you
should also examine the tires for
damage, foreign objects, and wear.
You should look for:
Bumps or bulges in the tread or
side of the tire. Replace the tire if
you find either of these conditions.
Cuts, splits, or cracks in the side
of the tire. Repla
Engine Coolant
Adding Engine Coolant
If the coolant level in the reserve
tank is at or below the MIN line, add
coolant to bring it up to the MAX line.
Inspect the cooling system for leaks.
Always use Honda Long-life Antifreeze/
Coolant Type 2. This coolant
is pre-mixed with 50 percent
antifreeze and
© 2016-2026 Copyright www.hcrv.net
