Honda CR-V: PGM-FI System

Component Location Index

Honda CR-V. PGM-FI System

Honda CR-V. PGM-FI System

READ NEXT:

 DTC Troubleshooting

 DTC P0101: MAF Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P1128, P1129, P2228, and/or P2229 are stored at the sa

 DTC P0111: IAT Sensor Circuit Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Check for poor connections or loose terminals at ECT sensor 1/2

SEE MORE:

 Blower Unit Removal/Installation

1. Remove the glove box. 2. Disconnect the connector (A), then remove the connector clip (B), the wire harness clips (C), the bolts, and the glove box frame (D). 3. Cut the plastic cross brace (A) in the glove box opening with diagonal cutters in the area shown. Retain plastic cross brace to be r

 Steering Column

Steering Column Removal and Installation SRS components are located in this area. Review the SRS component locations and the precautions and procedures before doing repairs or service. Removal NOTICE Be careful not to pull the bracket (A) on the front side of steering column out of its normal positi

© 2016-2026 Copyright www.hcrv.net