Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0443: EVAP Canister Purge Valve Circuit Malfunction

Special Tools Required Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A or equivalent, commercially available. NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and revie

 DTC P0451: FTP Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P2422 is stored at the same time as DTC P0451, trouble

 DTC P0453: FTP Sensor Circuit High Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the H

SEE MORE:

 Replacing a Parking Light/Front Side Marker Light Bulb

1. Open the hood. To change the parking light/front side marker on the driver’s side, remove the fuse box fromits stay by pulling out. 2. Remove the socket from the headlight assembly by turning it one-quarter turn counterclockwise. 3. Pull the bulb straight out of its socket. P

 DTC P0107: Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage Input

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Clear the DTC with the HDS. 2. Turn the ignition switch OFF, then turn it ON (II) again. 3. Check whether DTC P0107 is indicated in the DTCs/ Freeze Data in PGM-FI M

© 2016-2026 Copyright www.hcrv.net