Honda CR-V manuals

Honda CR-V: Idle Control System

Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Idle Control System

Component Location Index

Honda CR-V. Component Location Index

Honda CR-V. Component Location Index

READ NEXT:

 DTC Troubleshooting

DTC P0506: Idle Control System RPM Lower Than Expected NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the

 A/C Signal Circuit Troubleshooting

1. Start the engine, and let it idle. 2. Turn the blower switch on. 3. Turn the A/C switch on. 4. Check the A/C CLUTCH in the DATA LIST with the HDS. Does it indicate ON? YES-Go to step 5. 5. Check t

 PSP Switch Signal Circuit Troubleshooting

1. Start the engine, and let it idle. 2. Align the steering wheel straight ahead. 3. Check the PSP SWITCH in the DATA LIST with the HDS. Does it indicate ON? YES-Go to step 4. NO-Go to step 14. 4.

SEE MORE:

 DTC P1116: ECT Sensor 1 Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P0111 is stored at the same time as DTC P1116, troubleshoot DTC P0111 first, then recheck for DTC P1116. 1. Check for poor connections or loose terminal

 Door Lock

Door Lock Actuator Test Driver's Door and Left Rear Door 1. Remove the door panel. Front Rear 2. Disconnect the 10P connector (A) from the actuator (B). NOTE: The illustration shows the driver's door. 3. Check the actuator operation by connecting power and ground according to the table. To

© 2016-2025 Copyright www.hcrv.net