Honda CR-V: Cooling System

Component Location Index

Honda CR-V. Cooling System

READ NEXT:

 Radiator Cap Test

1. Remove the radiator cap (A), wet the seal with engine coolant, then install it on the pressure tester (B) (commercially available). 2. Apply a pressure of 93-123 kPa (0.95-1.25 kgf/cm2, 14-18 psi)

 Water Passage Replacement

1. Drain the engine coolant. 2. Remove the alternator. 3. Remove the condenser fan shroud assembly. 4. Remove the A/C compressor without disconnecting the A/C hoses (see step 34). 5. Remove the in

 EGR Passage Removal and Installation

Removal 1. Drain the engine coolant. 2. Remove the air cleaner housing. 3. Remove the harness holder (A) from the bracket, then remove the harness holder bracket (B). 4. Remove the upper radiator h

SEE MORE:

 Wiper Blades

Check the condition of the wiper blades at least every six months. Replace them if you find signs of cracking in the rubber, areas that are getting hard, or if they leave streaks and unwiped areas when used. To replace a front wiper blade: 1. Raise each wiper arm off the windshield, l

 Malfunction Indicator Lamp

If the indicator comes on while driving, it means one of the engine’s emissions control systems may have a problem. Even though you may feel no difference in your vehicle’s performance, it can reduce your fuel economy and cause increased emissions. Continued operation may cause

© 2016-2025 Copyright www.hcrv.net