Honda CR-V: PGM-FI System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / PGM-FI System
Component Location Index
-
CAMSHAFT POSITION (CMP) SENSOR B (EXHAUST)
-
OUTPUT SHAFT (COUNTERSHAFT) SPEED SENSOR
-
POWERTRAIN CONTROL MODULE (PCM)
-
ELECTRICAL LOAD DETECTOR (ELD) (bottom of fuse/relay box)
-
A/F SENSOR (LAF) RELAY (RELAY SOCKET E)
-
IGNITION COIL RELAY (RELAY SOCKET B)
-
MASS AIR FLOW (MAF) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR
-
ENGINE COOLANT TEMPERATURE (ECT) SENSOR 1
-
ENGINE COOLANT TEMPERATURE (ECT) SENSOR 2
-
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR
-
KNOCK SENSOR
-
INJECTORS
-
CRANKSHAFT POSITION (CKP) SENSOR
-
IGNITION COIL
-
DATA LINK CONNECTOR (DLC)
-
PGM-FI MAIN RELAY 2 (FUEL PUMP)
- DTC Troubleshooting
- F-CAN Circuit Troubleshooting
- DLC Circuit Troubleshooting
- Injector Replacement
- PCM Replacement
READ NEXT:
DTC P0101: MAF Sensor Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the sa
DTC P0111: IAT Sensor Circuit Range/Performance Problem
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Check for poor connections or loose terminals at
ECT sensor 1/2
SEE MORE:
Traction
The traction grades, from highest to
lowest, are AA, A, B, and C. Those
grades represent the tire’s ability to
stop on wet pavement as measured
under controlled conditions on
specified government test surfaces
of asphalt and concrete. A tire
marked C may have poor traction
performa
Maintenance
Lubricants and Fluids
For details of lubrication points and type of lubricants to be applied, refer
to the illustrated index and various work procedures (such as
Assembly/Reassembly, Replacement, Overhaul, Installation, etc.) contained in
each section.
API CERTIFICATION SEAL
Recommended Engine O
© 2016-2025 Copyright www.hcrv.net
