Honda CR-V manuals

Honda CR-V: Idle Control System

Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Idle Control System

Component Location Index

Honda CR-V. Component Location Index

Honda CR-V. Component Location Index

READ NEXT:

 DTC Troubleshooting

DTC P0506: Idle Control System RPM Lower Than Expected NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the

 A/C Signal Circuit Troubleshooting

1. Start the engine, and let it idle. 2. Turn the blower switch on. 3. Turn the A/C switch on. 4. Check the A/C CLUTCH in the DATA LIST with the HDS. Does it indicate ON? YES-Go to step 5. 5. Check t

 PSP Switch Signal Circuit Troubleshooting

1. Start the engine, and let it idle. 2. Align the steering wheel straight ahead. 3. Check the PSP SWITCH in the DATA LIST with the HDS. Does it indicate ON? YES-Go to step 4. NO-Go to step 14. 4.

SEE MORE:

 DLC Circuit Troubleshooting

NOTE: Make sure the HDS and the DLC cable of the HDS is not defective. 1. Turn the ignition switch OFF. 2. Connect the HDS to the DLC. NOTE: Make sure the HDS is properly connected to the DLC. 3. Turn the ignition switch ON (II). and read the HDS. Does the HDS identify the vehicle? YES-Go to ste

 Traction

The traction grades, from highest to lowest, are AA, A, B, and C. Those grades represent the tire’s ability to stop on wet pavement as measured under controlled conditions on specified government test surfaces of asphalt and concrete. A tire marked C may have poor traction performa

© 2016-2025 Copyright www.hcrv.net