Honda CR-V: TPMS (Tire Pressure Monitoring System)
Honda CR-V (2006–2011) Service Manual / Suspension / TPMS (Tire Pressure Monitoring System)
Component Location Index
- TPMS CONTROL UNIT
(Behind the dashboard center lower cover)
- Replacement
- TIRE PRESSURE SENSOR
- Replacement
- TIRE PRESSURE SENSOR
- Replacement
- UNDER-DASH FUSE/RELAY BOX
- TIRE PRESSURE SENSOR
- Replacement
- DATA LINK CONNECTOR (DLC)
- TIRE PRESSURE SENSOR
- Replacement
- UNDER-HOOD FUSE/RELAY BOX
- General Troubleshooting Information
- Memorizing the Tire Pressure Sensor ID
- DTC Troubleshooting
- Symptom Troubleshooting
- Tire Pressure Sensor Replacement
READ NEXT:
General Troubleshooting Information
System Indicator locations
The system has two indicators.
The low pressure indicator (A)
The TPMS indicator (B)
How TPMS Works
The TPMS (tire pressure monitoring system) has a low
pressure indica
Memorizing the Tire Pressure Sensor ID
Special Tools Required
TPMS sensor initializer tool AKS0620006
Available through the American Honda Tool and
Equipment program, 888-424-6857.
All four tire pressure sensor IDs must be memorized to
th
DTC Troubleshooting
DTC 11, 13, 15, 17: Low Tire Pressure
NOTE: If low tire pressure is detected, the control unit
sets one or more of these DTCs, and turns on the low
pressure indicator. If the low pressure indicator co
SEE MORE:
Quarter Glass Replacement
NOTE:
Put on gloves to protect your hands.
Wear eye protection when removing the glass with
piano wire.
Use seat covers to avoid damaging any surfaces.
The quarter glass molding will need replacement
because it will be damage during glass removal.
1. Remove the quarter pillar glass trim.
2.
Front Driveshaft Disassembly
Special Tools Required
Threaded adapter, 26 x 1.5 mm 07XAC-001030A
Slide hammer, 5/8"-18 UNF, commercially available
Inboard Joint Side
1. Remove the set ring (A) from the inboard joint.
2. Remove the boot bands. Be careful not to damage the boot.
3. Make marks (A) on each roller (B) and inboa
© 2016-2025 Copyright www.hcrv.net
