Honda CR-V: PGM-FI System
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / PGM-FI System
Component Location Index
-
CAMSHAFT POSITION (CMP) SENSOR B (EXHAUST)
-
OUTPUT SHAFT (COUNTERSHAFT) SPEED SENSOR
-
POWERTRAIN CONTROL MODULE (PCM)
-
ELECTRICAL LOAD DETECTOR (ELD) (bottom of fuse/relay box)
-
A/F SENSOR (LAF) RELAY (RELAY SOCKET E)
-
IGNITION COIL RELAY (RELAY SOCKET B)
-
MASS AIR FLOW (MAF) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR
-
ENGINE COOLANT TEMPERATURE (ECT) SENSOR 1
-
ENGINE COOLANT TEMPERATURE (ECT) SENSOR 2
-
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR
-
KNOCK SENSOR
-
INJECTORS
-
CRANKSHAFT POSITION (CKP) SENSOR
-
IGNITION COIL
-
DATA LINK CONNECTOR (DLC)
-
PGM-FI MAIN RELAY 2 (FUEL PUMP)
- DTC Troubleshooting
- F-CAN Circuit Troubleshooting
- DLC Circuit Troubleshooting
- Injector Replacement
- PCM Replacement
READ NEXT:
DTC P0101: MAF Sensor Range/Performance Problem
NOTE:
Before you troubleshoot, record all freeze data and
any on-board snapshot, and review the general
troubleshooting information.
If DTC P1128, P1129, P2228, and/or P2229 are stored
at the sa
DTC P0111: IAT Sensor Circuit Range/Performance Problem
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Check for poor connections or loose terminals at
ECT sensor 1/2
SEE MORE:
VSA OFF Switch
This switch is under the driver’s side
vent. To turn the VSA system on and
off, press and hold it until you hear a
beep.
When VSA is off, the VSA off
indicator comes on as a reminder.
Press and hold the switch again. It
turns the system back on.
VSA is turned on every time you
sta
Driveshaft Inspection
1. Check the inboard boot (A) and the outboard boot
(B) on the driveshaft (C) for cracks, damage, leaking
grease, and loose boot bands (D). If any damage is
found, replace the boot and boot bands.
2. Turn the driveshaft by hand, and make sure the
splines (E) and joint are not excessively loose.
3.
© 2016-2025 Copyright www.hcrv.net
