Honda CR-V: VSA (Vehicle Stability Assist) System Components
Honda CR-V (2006–2011) Service Manual / Brakes / VSA (Vehicle Stability Assist) System Components
Component Location Index
- VSA MODULATOR-CONTROL UNIT
- Removal and Installation
- UNDER-HOOD FUSE/RELAY BOX
- DATA LINK CONNECTOR (DLC)
- STEERING ANGLE SENSOR
- Replacement
- VSA OFF SWITCH
- Test
- RIGHT-REAR WHEEL SENSOR
- Replacement
- HUB BEARING UNIT
(MAGNETIC ENCODER)
- Replacement
- LEFT-REAR WHEEL SENSOR
- Replacement
- HUB BEARING UNIT
(MAGNETIC ENCODER)
- Replacement
- UNDER-DASH FUSE/RELAY BOX
- LEFT-FRONT WHEEL SENSOR
- Replacement
- WHEEL BEARING
(MAGNETIC ENCODER)
- Replacement
- YAW RATE-LATERAL
ACCELERATION SENSOR
- Replacement
- RIGHT-FRONT WHEEL SENSOR
- Replacement
- WHEEL BEARING
(MAGNETIC ENCODER)
- Replacement
- General Troubleshooting Information
- System Description
- DTC Troubleshooting
- Symptom Troubleshooting
- Steering Angle Sensor Replacement
READ NEXT:
General Troubleshooting Information
System Indicator
This system has four indicators:
ABS indicator (A)
Brake system indicator (B)
VSA indicator (C)
VSA activation indicator (D)
When the system detects a problem, it will turn the
System Description
VSA Modulator-control Unit Inputs and Outputs for 46P Connector
System Outline
This system is composed of the VSA modulator-control unit, the wheel sensors,
the steering angle sensor, and the
yaw
SEE MORE:
DTC Troubleshooting
DTC indicator 1: An Open in the Air Mix
Control Motor Circuit
1. Start the engine.
2. Turn on the A/C, then set the temperature control
dial to Max Hot.
3. Turn the ignition switch OFF and then ON (II).
4. Do the self-diagnostic with the HVAC control unit.
5. Check for DTCs.
Is DTC 1 indicated?
Idle Control System
Component Location Index
POWER STEERING PRESSURE (PSP) SWITCH
Signal Circuit Troubleshooting
A/C COMPRESSOR
CLUTCH RELAY
(RELAY SOCKET A)
Signal Circuit Troubleshooting
POWERTRAIN CONTROL
MODULE (PCM)
General Troubleshooting Information
Replacement
A/C
© 2016-2025 Copyright www.hcrv.net
