Honda CR-V: Cooling System
Honda CR-V (2006–2011) Service Manual / Engine Cooling / Cooling System
Component Location Index
-
COOLANT SEPARATOR
-
EXHAUST GAS RECIRCULATION (EGR) PASSAGE
-
THERMOSTAT
-
RADIATOR
-
ENGINE COOLANT TEMPERATURE (ECT) SENSOR 2
-
RADIATOR FAN ASSEMBLY
-
A/C CONDENSER FAN ASSEMBLY
-
WATER PUMP
-
WATER PASSAGE
- Radiator Cap Test
- Water Passage Replacement
- EGR Passage Removal and Installation
- Fan, Fan Motor, Shroud Removal and Installation
- Radiator Replacement
READ NEXT:
Radiator Cap Test
1. Remove the radiator cap (A), wet the seal with
engine coolant, then install it on the pressure tester
(B) (commercially available).
2. Apply a pressure of 93-123 kPa
(0.95-1.25 kgf/cm2, 14-18 psi)
Water Passage Replacement
1. Drain the engine coolant.
2. Remove the alternator.
3. Remove the condenser fan shroud assembly.
4. Remove the A/C compressor without disconnecting
the A/C hoses (see step 34).
5. Remove the in
EGR Passage Removal and Installation
Removal
1. Drain the engine coolant.
2. Remove the air cleaner housing.
3. Remove the harness holder (A) from the bracket,
then remove the harness holder bracket (B).
4. Remove the upper radiator h
SEE MORE:
Side Engine Mount Bracket Replacement
1. Support the engine with a jack and wood block
under the oil pan.
2. Remove the upper torque rod.
3. Remove the ground cable (A), then remove the side
engine mount bracket (B).
4. Install the side engine mount bracket, then loosely
tighten the new bolt and nut (C), and loosely tighten
the bolt
DTC 28-3x ("x" can be 0 thru 9 or A thru F):
Short to Another Wire or Decreased
Resistance in Front Passenger's Seat Belt
Buckle Tensioner
Special Tools Required
SRS inflator simulator 07SAZ-TB4011A
SRS simulator lead K 070AZ-SNAA200
NOTE: Before doing this troubleshooting procedure, review SRS Precautions and
Procedures.
1. Erase the DTC memory.
2. Turn the ignition switch ON (II), and check that the
SRS indicator comes on for a
© 2016-2026 Copyright www.hcrv.net
