Honda CR-V: Front Suspension

READ NEXT:

 Knuckle/Hub/Wheel Bearing Replacement

Exploded View Special Tools Required Hub dis/assembly tool 07GAF-SD40100 Ball joint remover, 32 mm 07MAC-SL0A102 Ball joint remover, 28 mm 07MAC-SL0A202 Ball joint thread protector, 14 mm 071AF-

 Lower Ball Joint Replacement

Special Tools Required Ball joint remover, 32 mm 07MAC-SL0A 102 Ball joint thread protector, 14 mm 071AF-S3VA000 1. Remove the front wheel. 2. Remove the flange bolt and flange nuts from the lowe

 Stabilizer

Stabilizer Link Removal/Installation 1. Raise the front of the vehicle, and support it with safety stands in the proper locations. 2. Remove the front wheel. 3. Remove the flange nuts while holdi

SEE MORE:

 Component Replacement/Inspection After Deployment

NOTE: Before doing any SRS repairs, use the HDS SRS menu method to check for DTCs; refer to the DTC Troubleshooting Index for the less obvious deployed parts (seat belt tensioners, front impact sensors, side airbag sensors, etc.) Do not replace the ODS unit unless it is physically damaged or

 Exhaust Emissions Controls

The exhaust emissions controls include three systems: PGM-FI, ignition timing control, and three way catalytic converter. These three systems work together to control the engine’s combustion and minimize the amount of HC, CO, and NOx that comes out the tailpipe. The exhaust emissio

© 2016-2025 Copyright www.hcrv.net