Honda CR-V: DTC Troubleshooting
- DTC P0443: EVAP Canister Purge Valve Circuit Malfunction
- DTC P0451: FTP Sensor Range/Performance Problem
- DTC P0453: FTP Sensor Circuit High Voltage
- DTC P0455/P0456: EVAP System Large Leak Detected/Very Small Leak Detected
- DTC P0457: EVAP System Leak Detected/Fuel Fill Cap Loose or Missing
READ NEXT:
DTC P0443: EVAP Canister Purge Valve
Circuit Malfunction
Special Tools Required
Vacuum pump/gauge, 0-30 in.Hg, Snap-on YA4000A
or equivalent, commercially available.
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and revie
DTC P0451: FTP Sensor Range/Performance
Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P2422 is stored at the same time as DTC P0451,
trouble
DTC P0453: FTP Sensor Circuit High Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the H
SEE MORE:
Power Windows
Component Location Index
POWER WINDOW MASTER SWITCH
(With built-in control unit)
FRONT PASSENGER'S POWER WINDOW SWITCH
FRONT PASSENGER'S POWER WINDOW MOTOR
RIGHT REAR POWER WINDOW SWITCH
RIGHT REAR POWER WINDOW MOTOR
LEFT REAR POWER WINDOW SWITCH
LEFT REAR POWER WINDOW MOTOR
POWER WINDOW
Front Driveshaft Installation
1. Apply grease to the contact area (A) of the outboard
joint and front wheel bearing.
NOTE: Failure to apply grease may cause excessive
noise and vibration.
2. Install a new set ring (A) onto the set ring groove
(B) of the driveshaft (left driveshaft).
3. Apply 0.5-1.0 g (0.02-0.04 oz) of grease
© 2016-2025 Copyright www.hcrv.net
