Honda CR-V manuals

Honda CR-V: Charging System

Honda CR-V (2006–2011) Service Manual / Engine Electrical / Charging System

Component Location Index

Honda CR-V. Charging System

Symptom Troubleshooting Index

Charging system indicator does not come on with the ignition switch ON (II)

Charging system indicator stays on

  1. Check for PGM-FI DTCs
  2. Troubleshoot the charging system indicator circuit
  3. Check for a broken drive belt
  4. Check the drive belt auto-tensioner

Battery discharged

  1. Check for excessive parasitic electrical current draw
  2. Check for a broken drive belt
  3. Check the drive belt auto-tensioner
  4. Troubleshoot the alternator and regulator circuit
  5. Check for a poor connection at the battery terminal
  6. Test the battery

Battery overcharged

  1. Troubleshoot the alternator and regulator circuit
  2. Test the battery

Circuit Diagram

Honda CR-V. Charging System

READ NEXT:

 Charging System Indicator Circuit Troubleshooting

1. Turn the ignition switch ON (II). Does the charging system indicator come on? YES-Go to step 2. NO-Go to step 14. 2. Start the engine. Hold the engine speed at 2,000 rpm for 1 minute. Does the c

 Alternator and Regulator Circuit Troubleshooting

1. Make sure the battery connections are good and the battery is sufficiently charged. 2. Connect a VAT-40 (or equivalent tester), and turn the selector switch to position 1 (starting). 3. Start the

 Drive Belt Inspection

1. Inspect the belt for cracks and damage. If the belt is cracked or damaged, replace it. 2. Check that the auto-tensioner indicator (A) is within the standard range (B) as shown. If it is out of the

SEE MORE:

 DTC 11-1x/4x ("x" can be 0 thru 9 or A thru F) : Open or Increased Resistance in Driver's Airbag First/Second Inflator

DTC 11-1x ("x" can be 0 thru 9 or A thru F): Open or Increased Resistance in Driver's Airbag First Inflator DTC 11-4x ("x" can be 0 thru 9 or A thru F): Open or Increased Resistance in Driver's Airbag Second Inflator Special Tools Required SRS inflator simulator 07SAZ-TB4011A SRS simulator lead J

 F-CAN Circuit Troubleshooting

NOTE: Information marked with an asterisk (*) applies to the CANL line. 1. Turn the ignition switch OFF. 2. Jump the SCS line with the HDS. 3. Disconnect PCM connector A (44P), then disconnect the HDS. 4. Measure resistance between PCM connector terminals A36 and A37. Is there about 95- 116 Ω

© 2016-2025 Copyright www.hcrv.net