Honda CR-V: Dashboard

READ NEXT:

 Center Upper Dashboard Panel Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Use the appropr

 Driver's Vent Panel Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Put on gloves to protect your hands. Use the appropr

 Passenger's Tray Removal/Installation

Special Tools Required KTC trim tool set SOJATP2014 * * Available through the American Honda Tool and Equipment Program; call 888-424-6857 SRS components are located in this area. Review the SRS compo

SEE MORE:

 DTC P0107: Manifold Absolute Pressure (MAP) Sensor Circuit Low Voltage Input

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Clear the DTC with the HDS. 2. Turn the ignition switch OFF, then turn it ON (II) again. 3. Check whether DTC P0107 is indicated in the DTCs/ Freeze Data in PGM-FI M

 If You Get Stuck

Avoid driving on soft sand, deep mud, or other surfaces where you could get stuck. If you do happen to get stuck because of inclement weather or other conditions, choose a safe and appropriate course of action. You should never use a jack to try getting unstuck. A jack only works on f

© 2016-2025 Copyright www.hcrv.net