Honda CR-V: PGM-FI System

Component Location Index

Honda CR-V. PGM-FI System

Honda CR-V. PGM-FI System

READ NEXT:

 DTC Troubleshooting

 DTC P0101: MAF Sensor Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P1128, P1129, P2228, and/or P2229 are stored at the sa

 DTC P0111: IAT Sensor Circuit Range/Performance Problem

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Check for poor connections or loose terminals at ECT sensor 1/2

SEE MORE:

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch. 4. Inspect the connector terminals to be sure they are all making good contact. If the terminals a

 XM radio display is blank and no station information is displayed

1. Disconnect audio disc changer 13P connector. 2. Turn the ignition switch to ACC (I). 3. Operate the XM radio, and check the display. Is XM information displayed? YES-Replace the audio disc changer. NO-Go to step 4. 4. Check the No. 34 (7.5 A) fuse in the under-dash fuse/relay box and the No.

© 2016-2025 Copyright www.hcrv.net