Honda CR-V: Adjusting the Sound

Press the sound ( select an appropriate setting: bass, ) button to select an appropriate setting: bass, treble, fader, balance, subwoofer (if equipped), and SVC (speed-sensitive volume compensation). Turn the VOL/SELECT knob to adjust the setting.

BAS - Adjusts the bass.

TREBLE - Adjusts the treble.

FADER - Adjusts the front-to-back strength of the sound.

BALANCE - Adjusts the side-toside strength of the sound.

If equipped

SUBW - Adjusts the strength of sound from the subwoofer speaker.

Eachmode is shown in the display as it changes. Turn the VOL/SELECT knob to adjust the setting to your liking. When the level reaches the center, you will see ‘‘C’’ in the display.

SVC - Adjusts the volume level based on the vehicle speed.

The system will return to the audio display about 10 seconds after you stop adjusting a mode.

Speed-sensitive Volume Compensation (SVC)

The SVC mode controls the volume based on vehicle speed. The faster you go, the louder the audio volume becomes. As you slow down, the audio volume decreases.

The SVC has four modes; SVC OFF, SVC LOW, SVC MID, and SVC HIGH. Turn the VOL/SELECT knob to adjust the setting to your liking. If you feel the sound is too loud, choose low. If you feel the sound is too quiet, choose high.

This function is set to MID as the default setting when the vehicle leaves the factory.

READ NEXT:

 Audio System Lighting

You can use the instrument panel brightness control knob to adjust the illumination of the audio system. The audio system illuminates when the parking lights are on, even if the system is tu

 Playing the XM Radio

On EX-L without Navigation System Your vehicle is capable of receiving XM Radio anywhere in Canada and the United States, except Hawaii, Alaska, and Puerto Rico. XM CANADA is a registered bus

 Operating the XM Radio

To listen to XM radio, turn the ignition switch to the ACCESSORY (I) or the ON (II) position. Push the button to turn on the audio system, and press the ‘‘XM’’ button. Adjust the vol

SEE MORE:

 Rear Seat

Rear Seat Armrest Removal/Installation NOTE: Take care not to tear the seams or damage the seat covers. 1. Remove the E-ring (A) from the right side portion on the armrest pivot. 2. Slide the armrest (A) toward the right side, then release the left pivot shaft (B) from the bushing (C). 3. Release

 Transmission Removal/Installation

Transmission Removal Special Tools Required Engine hanger adapter VSB02C000015 CR-V engine hanger adapter VSB02C000032 Front subframe adapter VSB02C000016 Engine support hanger, A and Reds AAR-T-12566 These special tools are available through the Honda Tool and Equipment Program 1-888-424-6857

© 2016-2025 Copyright www.hcrv.net