Honda CR-V: PGM-FI System

Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / PGM-FI System

Component Location Index

Honda CR-V. PGM-FI System

CAMSHAFT POSITION (CMP) SENSOR B (EXHAUST)
OUTPUT SHAFT (COUNTERSHAFT) SPEED SENSOR
POWERTRAIN CONTROL MODULE (PCM)
ELECTRICAL LOAD DETECTOR (ELD) (bottom of fuse/relay box)
A/F SENSOR (LAF) RELAY (RELAY SOCKET E)
IGNITION COIL RELAY (RELAY SOCKET B)
MASS AIR FLOW (MAF) SENSOR/INTAKE AIR TEMPERATURE (IAT) SENSOR
ENGINE COOLANT TEMPERATURE (ECT) SENSOR 1
ENGINE COOLANT TEMPERATURE (ECT) SENSOR 2
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR
KNOCK SENSOR
INJECTORS
CRANKSHAFT POSITION (CKP) SENSOR
IGNITION COIL

Honda CR-V. PGM-FI System

DATA LINK CONNECTOR (DLC)
PGM-FI MAIN RELAY 2 (FUEL PUMP)

SEE MORE:

Cylinder Head Installation

1. Install a new coolant separator in the engine block whenever the engine block is replaced. 2. Clean the cylinder head and block surface. 3. Install the new cylinder head gasket (A) and dowel pins (B) on the engine block. Always use a new cylinder head gasket. Set the crankshaft to top dead cen

DTC P1009: VTC Advance Malfunction

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. If DTC P0341 is stored at the same time as DTC P1009, troubleshoot DTC P1009 first, then recheck for DTC P0341. 1. Turn the ignition switch ON (II). 2. Clear

Honda CR-V: PGM-FI System

READ NEXT:

DTC Troubleshooting

DTC P0101: MAF Sensor Range/Performance Problem

DTC P0111: IAT Sensor Circuit Range/Performance Problem

SEE MORE:

Cylinder Head Installation

DTC P1009: VTC Advance Malfunction