Honda CR-V: Idle Control System
Component Location Index

- POWER STEERING PRESSURE (PSP) SWITCH
- Signal Circuit Troubleshooting
- A/C COMPRESSOR
CLUTCH RELAY
(RELAY SOCKET A)
- Signal Circuit Troubleshooting
- POWERTRAIN CONTROL
MODULE (PCM)
- General Troubleshooting Information
- Replacement
- A/C COMPRESSOR
- ALTERNATOR
- Signal Circuit Troubleshooting
- A/C PRESSURE SENSOR

- BRAKE PEDAL POSITION SWITCH
- Signal Circuit Troubleshooting
READ NEXT:
DTC P0506: Idle Control System RPM Lower
Than Expected
NOTE: Before you troubleshoot, record all freeze data
and any on-board snapshot, and review the general
troubleshooting information.
1. Turn the
1. Start the engine, and let it idle.
2. Turn the blower switch on.
3. Turn the A/C switch on.
4. Check the A/C CLUTCH in the DATA LIST with the
HDS.
Does it indicate ON?
YES-Go to step 5.
5. Check t
1. Start the engine, and let it idle.
2. Align the steering wheel straight ahead.
3. Check the PSP SWITCH in the DATA LIST with the
HDS.
Does it indicate ON?
YES-Go to step 4.
NO-Go to step 14.
4.
SEE MORE:
CAUTION
Headlights become very hot during use; do not
touch them or any attaching hardware immediately
after they have been turned off.
Before adjusting the headlights:
Park the vehicle on a level surface.
Make sure the tire pressures are correct.
The driver or someone who weighs the same should
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Start the engine. Hold the engine speed between
3,000 rpm without load (in Park or neutral) u
© 2016-2025 Copyright www.hcrv.net
