Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0122: TP Sensor A Circuit Low Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HD

 DTC P1658: ETCS Control Relay ON Malfunction

NOTE: Before you troubleshoot. record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Do the ETCS TEST in the

 DTC P1683: Throttle Valve Default Position Spring Performance Problem

CAUTION Do not insert your fingers into the installed throttle body when you turn the ignition switch ON (II) or while the ignition switch is ON (II). If you do, you will seriously injure your fingers

SEE MORE:

 Moonroof

Component Location Index GLASS DRAIN CHANNEL SUNSHADE CABLE ASSEMBLY CABLE TUBE REAR BRACKET MOTOR WIND DEFLECTOR REAR DRAIN TUBE REAR DRAIN VALVE FRAME CLIP FRONT DRAIN VALVE FRONT DRAIN TUBE Symptom Troubleshooting Index Glass Position Adjustment The roof panel (A) should be ev

 Front Door

Front Door Panel Removal/Installation Special Tools Required KTC trim tool set SOJATP2014 * Trim pad remover, Snap-on A 177 A or equivalent, commercially available * Available through the American Honda Tool and Equipment Program; call 888-424-6857 NOTE: Use the appropriate tool from the KT

© 2016-2026 Copyright www.hcrv.net