Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0122: TP Sensor A Circuit Low Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HD

 DTC P1658: ETCS Control Relay ON Malfunction

NOTE: Before you troubleshoot. record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Do the ETCS TEST in the

 DTC P1683: Throttle Valve Default Position Spring Performance Problem

CAUTION Do not insert your fingers into the installed throttle body when you turn the ignition switch ON (II) or while the ignition switch is ON (II). If you do, you will seriously injure your fingers

SEE MORE:

 Wiper Blades

Check the condition of the wiper blades at least every six months. Replace them if you find signs of cracking in the rubber, areas that are getting hard, or if they leave streaks and unwiped areas when used. To replace a front wiper blade: 1. Raise each wiper arm off the windshield, l

 Disc Player Error Messages (EX and EX-L models without navigation system)

If you see an error message in the display while playing a disc, find the cause in the chart to the right. If you cannot clear the error message, take your vehicle to your dealer. The chart on the right explains the error messages you may see in the display while playing a disc. If you

© 2016-2025 Copyright www.hcrv.net