Honda CR-V: DTC Troubleshooting
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Electronic Throttle Control System / DTC Troubleshooting
- DTC P0122: TP Sensor A Circuit Low Voltage
- DTC P1658: ETCS Control Relay ON Malfunction
- DTC P1683: Throttle Valve Default Position Spring Performance Problem
- DTC P2101: Electronic Throttle Control System (ETCS) Malfunction
- DTC P2122: APP Sensor A (Throttle Position Sensor D) Circuit Low Voltage
- DTC P2135: TP Sensor A/B Voltage Incorrect Correlation
READ NEXT:
DTC P0122: TP Sensor A Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HD
DTC P1658: ETCS Control Relay ON
Malfunction
NOTE: Before you troubleshoot. record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Do the ETCS TEST in the
DTC P1683: Throttle Valve Default Position
Spring Performance Problem
CAUTION
Do not insert your fingers into the installed throttle
body when you turn the ignition switch ON (II) or
while the ignition switch is ON (II). If you do, you
will seriously injure your fingers
SEE MORE:
Differential Reassembly
Exploded View
Special Tools Required
Holder handle 07JAB-001020A
Companion flange holder 07RAB-TB4010B
1. Apply differential fluid to the rubber pinion of the
ATF strainer (A), then install the ATF strainer, the
magnet (B), the dowel pins (C), and the oil pump
pin (D), in the differential carri
Beverage Holders
Be careful when you are using the
beverage holders. A spilled liquid
that is very hot can scald you or your
passengers. Liquid can also spill
from the door pocket beverage
holders when you open or close the
doors. Use only resealable
containers in the door pockets.
Spilled liquids can
© 2016-2025 Copyright www.hcrv.net
