Honda CR-V: DTC Troubleshooting
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Electronic Throttle Control System / DTC Troubleshooting
- DTC P0122: TP Sensor A Circuit Low Voltage
- DTC P1658: ETCS Control Relay ON Malfunction
- DTC P1683: Throttle Valve Default Position Spring Performance Problem
- DTC P2101: Electronic Throttle Control System (ETCS) Malfunction
- DTC P2122: APP Sensor A (Throttle Position Sensor D) Circuit Low Voltage
- DTC P2135: TP Sensor A/B Voltage Incorrect Correlation
READ NEXT:
DTC P0122: TP Sensor A Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HD
DTC P1658: ETCS Control Relay ON
Malfunction
NOTE: Before you troubleshoot. record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Do the ETCS TEST in the
DTC P1683: Throttle Valve Default Position
Spring Performance Problem
CAUTION
Do not insert your fingers into the installed throttle
body when you turn the ignition switch ON (II) or
while the ignition switch is ON (II). If you do, you
will seriously injure your fingers
SEE MORE:
Replacing a High-mount Brake Light Bulb
1. Open the tailgate.
Unlatch the top of the cover by
pulling back on it with your hands.
2. Place a cloth on the side edge of
the cover to prevent scratches.
Remove the cover by carefully
prying on the edge with a small
flat-tip screwdriver and pulling the
cover off.
3. Remove the
Column Cover Removal/Installation
SRS components are located in this area. Review the
SRS component locations and the
precautions and procedures before
doing repairs or service.
NOTE: Take care not to scratch the dashboard and
related parts.
1. Release the tilt/telescopic lock lever, tilt the
steering wheel to fully down, and pull
© 2016-2025 Copyright www.hcrv.net
