Honda CR-V: Rear Suspension

READ NEXT:

 Knuckle/Hub Bearing Unit Replacement

Exploded View Hub Bearing Unit Replacement 1. Raise the rear of the vehicle, and support it with safety stands in the proper locations. 2. Remove the wheel nuts (A) and the rear wheel. 3. Remove t

 Upper Arm Replacement

1. Raise the rear of the vehicle, and support it with safety stands in the proper locations. 2. Remove the rear wheel. 3. Place a floor jack under the trailing arm, and support the suspension. 4.

 Damper/Spring

Damper/Spring Removal and Installation Removal 1. Raise the rear of the vehicle, and support it with safety stands in the proper locations. 2. Remove the rear wheel. 3. Remove the lid (A) on the

SEE MORE:

 Potential Vehicle Hazards

Carbon Monoxide poison from engine exhaust. Be sure there is adequate ventilation whenever you operate the engine. Burns from hot parts. Let the engine and exhaust system cool down before touching any parts. Injury from moving parts. Do not run the engine unless instructed to do so.

 Connectors and Harnesses

Connector Index Identification numbers have been assigned to in-line connectors, junction connectors, and terminals. The number is preceded by the letter ºC" for connectors "G" for ground terminals or "T" for non-ground terminals. * 1. With seat heater * 2: Without seat heater Connector to Harne

© 2016-2026 Copyright www.hcrv.net