Honda CR-V: Exterior Lights
Honda CR-V (2006–2011) Service Manual / Body Electrical / Exterior Lights
Component Location Index
- DAYTIME RUNNING LIGHTS CIRCUIT
- HEADLIGHTS
- FRONT SIDE MARKER/PARKING/ TURN SIGNAL LIGHTS
- HIGH MOUNT BRAKE LIGHT
- LICENSE PLATE LIGHT
- TAILLIGHT and BRAKE LIGHT
- REAR TURN SIGNAL LIGHT
- BACK-UP LIGHT
- LIGHTS-ON INDICATOR
- HIGH BEAM INDICATOR
- DRL INDICATOR
- COMBINATION LIGHT SWITCH
- BRAKE PEDAL POSITION SWITCH
READ NEXT:
System Description
Headlights System Description
The headlight system is composed of the MICU, the headlight and
dimmer/flash-to-pass switches (inside the
combination light switch), the left and right headlights, and t
DTC Troubleshooting
DTC B1078: Daytime Running Lights Signal
Error (Canada)
DTC B1079: Daytime Running Lights Signal
Error (USA)
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN
MICU Input Test
NOTE:
The MICU turns on the headlights (high beams) in a dim mode for the
daytime running lights under the following
conditions:
The ignition switch is ON (II)
The headlight switch is OFF
T
SEE MORE:
DTC P0451: FTP Sensor Range/Performance
Problem
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
If DTC P2422 is stored at the same time as DTC P0451,
troubleshoot DTC P2422 first, then recheck for DTC
P0451.
1. Turn the ignition switch ON (II).
2. Clear
Camshaft Inspection
NOTE: Do not rotate the camshaft during inspection.
1. Remove the rocker arm assembly.
2. Put the rocker shaft holders, camshaft, and
camshaft holders on the cylinder head, then tighten
the bolts, in sequence, to the specified torque.
NOTE: If the engine does not have bolt 21, skip it
and continu
© 2016-2026 Copyright www.hcrv.net
