Honda CR-V: Rear Window Defogger

The rear window defogger will clear

The rear window defogger will clear fog, frost, and thin ice from the window. Push the defogger button to turn it on and off. The indicator in the button comes on to show the defogger is on. It also shuts off when you turn off the ignition switch. You have to turn the defogger on again when you restart the vehicle.

On vehicles with automatic air conditioning system

The defogger will shut itself off within about 10 to 30 minutes according to the outside temperature.

Make sure the rear window is clear and you have good visibility before starting to drive.

The defogger wires on the inside of the rear window can be accidentally damaged. When cleaning the glass, always wipe side-to-side.

If equipped

Pushing this button also turns the mirror heaters on or off.

READ NEXT:

 Parking Brake

To apply the parking brake, push the pedal down with your foot. To release it, push on the pedal again. The parking brake indicator on the instrument panel should go out when the parking

 Steering Wheel Adjustment

Make any steering wheel adjustment before you start driving. Adjusting the steering wheel position while driving may cause you to lose control of the vehicle and be seriously injured in

 Keys and Locks

The master key fits all the locks on your vehicle. The valet key works only in the ignition and the driver’s door lock. You can keep the glove box locked when you leave your vehicle an

SEE MORE:

 Relay and Control Unit Locations

Engine Compartment VSA MODULATOR-CONTROL UNIT AUXILIARY UNDER-HOOD RELAY BOX POWER MIRROR DEFOGGER RELAY PCM RADIATOR FAN RELAY ELECTRONIC THROTTLE CONTROL SYSTEM (ETCS) CONTROL RELAY ELD UNIT PGM-FI MAIN RELAY 1 (FI MAIN) UNDER-HOOD FUSE/RELAY BOX FAN CONTROL RELAY BLOWER MOTOR RELAY

 DTC 11, 13, 15, 17: Wheel Sensor (Open/Short to Body Ground/Short to Power)

1. Turn the ignition switch ON (II). 2. Check for DTCs with the HDS. Is DTC 87 indicated with DTC 11,13,15, and/or 17 at the same time? YES-Go to step 9. NO-Go to step 3. 3. Clear the DTC with the HDS. 4. Turn the ignition switch OFF, then turn it ON (II) again. 5. Check for DTCs with the HDS.

© 2016-2025 Copyright www.hcrv.net