Honda CR-V: Exterior Lights
Component Location Index

- DAYTIME RUNNING LIGHTS CIRCUIT
- HEADLIGHTS
- FRONT SIDE MARKER/PARKING/
TURN SIGNAL LIGHTS

- HIGH MOUNT BRAKE LIGHT
- LICENSE PLATE LIGHT
- TAILLIGHT and BRAKE LIGHT
- REAR TURN SIGNAL LIGHT
- BACK-UP LIGHT

- LIGHTS-ON INDICATOR
- HIGH BEAM INDICATOR
- DRL INDICATOR
- COMBINATION LIGHT SWITCH
- BRAKE PEDAL POSITION SWITCH
READ NEXT:
Headlights System Description
The headlight system is composed of the MICU, the headlight and
dimmer/flash-to-pass switches (inside the
combination light switch), the left and right headlights, and t
DTC B1078: Daytime Running Lights Signal
Error (Canada)
DTC B1079: Daytime Running Lights Signal
Error (USA)
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN
NOTE:
The MICU turns on the headlights (high beams) in a dim mode for the
daytime running lights under the following
conditions:
The ignition switch is ON (II)
The headlight switch is OFF
T
SEE MORE:
1. Remove the radiator cap (A), wet the seal with
engine coolant, then install it on the pressure tester
(B) (commercially available).
2. Apply a pressure of 93-123 kPa
(0.95-1.25 kgf/cm2, 14-18 psi).
3. Check for a drop in pressure.
4. If the pressure drops, replace the cap.
Radiator Test
1. W
DTC P0716: Problem in Input Shaft
(Mainshaft) Speed Sensor Circuit
DTC P0717: Problem in Input Shaft
(Mainshaft) Speed Sensor Circuit (No Signal
Input)
NOTE:
Before you troubleshoot, record all freeze data and any on-board
snapshot, and review General Troubleshooting Information.
This code is c
© 2016-2026 Copyright www.hcrv.net
