Honda CR-V: DTC Troubleshooting

READ NEXT:

 DTC P0122: TP Sensor A Circuit Low Voltage

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Clear the DTC with the HD

 DTC P1658: ETCS Control Relay ON Malfunction

NOTE: Before you troubleshoot. record all freeze data and any on-board snapshot, and review the general troubleshooting information. 1. Turn the ignition switch ON (II). 2. Do the ETCS TEST in the

 DTC P1683: Throttle Valve Default Position Spring Performance Problem

CAUTION Do not insert your fingers into the installed throttle body when you turn the ignition switch ON (II) or while the ignition switch is ON (II). If you do, you will seriously injure your fingers

SEE MORE:

 Radiator Cap Test

1. Remove the radiator cap (A), wet the seal with engine coolant, then install it on the pressure tester (B) (commercially available). 2. Apply a pressure of 93-123 kPa (0.95-1.25 kgf/cm2, 14-18 psi). 3. Check for a drop in pressure. 4. If the pressure drops, replace the cap. Radiator Test 1. W

 SRS (Supplemental Restraint System)

Component Location Index SRS INDICATOR SIDE AIRBAG CUTOFF INDICATOR MEMORY ERASE SIGNAL (MES) CONNECTOR (2P) (YELLOW) CABLE REEL PASSENGER'S AIRBAG CUTOFF INDICATOR FRONT PASSENGER'S AIRBAG DRIVER'S AIRBAG OPDS SENSOR/SEAT-BACK FRONT PASSENGER'S SIDE AIRBAG RIGHT SIDE IMPACT SENSOR

© 2016-2026 Copyright www.hcrv.net