Honda CR-V: Steering Gearbox

READ NEXT:

 Steering Gearbox Removal

Special Tools Required Ball joint remover, 28 mm 07MAC-SL0A202 Note these items during removal: Using solvent and a brush, wash any oil and dirt off the valve body unit, it's lines, and the end of

 Steering Gearbox Overhaul

Exploded View Special Tools Required Cylinder end seal remover attachment 070AF-S7S0100 Valve seal ring sizing tool 07NAG-SR3090A Sleeve seal ring guide 07YAG-S2X0100 Sleeve seal ring sizing t

 Steering Gearbox Installation

NOTE: The illustrations show 2WD. 1. Before installing the steering gearbox, make sure that no power steering fluid is on the mating surface of the steering gearbox and the front subframe. To prevent

SEE MORE:

 Turn Signal/Hazard Flasher

Component Location Index TURN SIGNAL SWITCH (Built into the combination light switch) TURN SIGNAL INDICATORS HAZARD WARNING SWITCH MICU (Built into the under-dash fuse/relay box) Circuit Diagram MICU Input Test NOTE: Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A. 1.

 Accessory Power Sockets

Your vehicle has two or three accessory power sockets depending on the model. To use an accessory power socket, the ignition switch must be in the ACCESSORY (I) or ON (II) position. Each socket is intended to supply power for 12 volt DC accessories that are rated 120 watts or l

© 2016-2025 Copyright www.hcrv.net