Honda CR-V: Exterior Lights
Honda CR-V (2006–2011) Service Manual / Body Electrical / Exterior Lights
Component Location Index
- DAYTIME RUNNING LIGHTS CIRCUIT
- HEADLIGHTS
- FRONT SIDE MARKER/PARKING/ TURN SIGNAL LIGHTS
- HIGH MOUNT BRAKE LIGHT
- LICENSE PLATE LIGHT
- TAILLIGHT and BRAKE LIGHT
- REAR TURN SIGNAL LIGHT
- BACK-UP LIGHT
- LIGHTS-ON INDICATOR
- HIGH BEAM INDICATOR
- DRL INDICATOR
- COMBINATION LIGHT SWITCH
- BRAKE PEDAL POSITION SWITCH
READ NEXT:
System Description
Headlights System Description
The headlight system is composed of the MICU, the headlight and
dimmer/flash-to-pass switches (inside the
combination light switch), the left and right headlights, and t
DTC Troubleshooting
DTC B1078: Daytime Running Lights Signal
Error (Canada)
DTC B1079: Daytime Running Lights Signal
Error (USA)
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN
MICU Input Test
NOTE:
The MICU turns on the headlights (high beams) in a dim mode for the
daytime running lights under the following
conditions:
The ignition switch is ON (II)
The headlight switch is OFF
T
SEE MORE:
Rear Driveshaft
Rear Driveshaft Removal
1. Raise the vehicle on a lift, and remove the rear
wheels.
2. Lift up the locking tab (A) on the spindle nut (B),
then remove the nut.
3. Drain the differential fluid.
4. Remove the rear driveshaft inboard joint from the rear differential assembly.
5. Disconnect the rear
Cam Chain Inspection
1. Remove the front wheels.
2. Remove the splash shield (see step 21).
3. Remove the drive belt.
4. Remove the cylinder head cover.
5. Set the No.1 piston at top dead center (TDC). The
punch mark on the variable valve timing control
(VTC) actuator and the punch mark on the exhaust
camshaft sproc
© 2016-2025 Copyright www.hcrv.net
