Honda CR-V: Wipers/Washers

Component Location Index

Honda CR-V. Wipers/Washers

Honda CR-V. Wipers/Washers

Honda CR-V. Wipers/Washers

Honda CR-V. Wipers/Washers

Circuit Diagram - Windshield

Honda CR-V. Wipers/Washers

Circuit Diagram - Rear Window

Honda CR-V. Wipers/Washers

READ NEXT:

 DTC Troubleshooting

DTC B1028: Rear Window Wiper Motor (As) Signal Error NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A. 1. Clear the DTCs with th

 MICU Input Test

1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A, and check the No.8 (10 A), No. 10 (7.5 A), and No. 38 (30 A) fuses in the under-dash fuse/relay box. 2. Disconnect under-dash

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch.

SEE MORE:

 DTC P2122: Accelerator Pedal Position (APP) Sensor A (Throttle Position Sensor D) Circuit Low Voltage Input

NOTE: Before you troubleshoot, record all freeze data and any on-board snapshot, and review General Troubleshooting Information. 1. Clear the DTC with the HDS. 2. Turn the ignition switch ON. 3. Check whether DTC P2122 is indicated in the DTCs/ Freeze Data in PGM-FI Mode Menu with the HDS. Is D

 Water Passage Replacement

1. Drain the engine coolant. 2. Remove the alternator. 3. Remove the condenser fan shroud assembly. 4. Remove the A/C compressor without disconnecting the A/C hoses (see step 34). 5. Remove the intake manifold. 6. Remove the bolt (A) securing the connecting pipe. 7. Remove the lower radiator h

© 2016-2025 Copyright www.hcrv.net