Honda CR-V: Wipers/Washers
Honda CR-V (2006–2011) Service Manual / Body Electrical / Wipers/Washers
Component Location Index
- WINDSHIELD WIPER BLADES
- WIPER/WASHER SWITCH
- WINDSHIELD WIPER ARMS and LINK
- WINDSHIELD WIPER MOTOR
- UNDER-DASH FUSE/RELAY BOX
- UNDER-HOOD FUSE/RELAY BOX
- INTERMITTENT WIPER RELAY CIRCUIT (Built into the MICU)
- REAR WIPER BLADE
- REAR WIPER ARM
- REAR WINDOW WIPER MOTOR
- WINDSHIELD WASHER NOZZLES
- WASHER RESERVOIR
- WASHER MOTOR
- WASHER FLUID LEVEL SWITCH (Canada models)
- WASHER TUBES
- REAR WINDOW WASHER NOZZLE
- WASHER TUBE
Circuit Diagram - Windshield
Circuit Diagram - Rear Window
READ NEXT:
DTC Troubleshooting
DTC B1028: Rear Window Wiper Motor (As)
Signal Error
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN System
Diagnosis Test Mode A.
1. Clear the DTCs with th
MICU Input Test
1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A, and
check the No.8
(10 A), No. 10 (7.5 A), and No. 38 (30 A) fuses in the under-dash fuse/relay
box.
2. Disconnect under-dash
Wiper/Washer Switch Test/Replacement
1. Remove the steering column covers.
2. Disconnect the dashboard wire harness 8P
connector (A) from the wiper/washer switch (B).
3. Remove the two screws, then slide out the wiper/
washer switch.
SEE MORE:
Changing the Engine Oil and Filter
Always change the oil and filter
according to the maintenance
messages shown on the information
display. The oil and filter collect
contaminants that can damage your
engine if they are not removed
regularly.
Changing the oil and filter requires
special tools and access from
undernea
Brake Fluid
Check the fluid level in the brake
fluid reservoir monthly.
Replace the brake fluid according to
the maintenance messages shown on
the information display.
Always use Honda Heavy Duty
Brake Fluid DOT 3. If it is not
available, you should use only DOT 3
or DOT 4 fluid, from a sealed
c
© 2016-2025 Copyright www.hcrv.net
