Honda CR-V: DTC Troubleshooting
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Electronic Throttle Control System / DTC Troubleshooting
- DTC P0122: TP Sensor A Circuit Low Voltage
- DTC P1658: ETCS Control Relay ON Malfunction
- DTC P1683: Throttle Valve Default Position Spring Performance Problem
- DTC P2101: Electronic Throttle Control System (ETCS) Malfunction
- DTC P2122: APP Sensor A (Throttle Position Sensor D) Circuit Low Voltage
- DTC P2135: TP Sensor A/B Voltage Incorrect Correlation
READ NEXT:
DTC P0122: TP Sensor A Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HD
DTC P1658: ETCS Control Relay ON
Malfunction
NOTE: Before you troubleshoot. record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Do the ETCS TEST in the
DTC P1683: Throttle Valve Default Position
Spring Performance Problem
CAUTION
Do not insert your fingers into the installed throttle
body when you turn the ignition switch ON (II) or
while the ignition switch is ON (II). If you do, you
will seriously injure your fingers
SEE MORE:
Wiper/Washer Switch Test/Replacement
1. Remove the steering column covers.
2. Disconnect the dashboard wire harness 8P
connector (A) from the wiper/washer switch (B).
3. Remove the two screws, then slide out the wiper/
washer switch.
4. Inspect the connector terminals to be sure they are
all making good contact.
If the terminals a
Overview of Contents
Contents
A convenient reference to the
sections in this manual.
Your Vehicle at a Glance
A quick reference to the main
controls in your vehicle.
Driver and Passenger Safety
Important information about the
proper use and care of your vehicle’s
seat belts, an overview of the
supplemen
© 2016-2025 Copyright www.hcrv.net
