Honda CR-V: DTC Troubleshooting
Honda CR-V (2006–2011) Service Manual / Fuel and Emissions / Electronic Throttle Control System / DTC Troubleshooting
- DTC P0122: TP Sensor A Circuit Low Voltage
- DTC P1658: ETCS Control Relay ON Malfunction
- DTC P1683: Throttle Valve Default Position Spring Performance Problem
- DTC P2101: Electronic Throttle Control System (ETCS) Malfunction
- DTC P2122: APP Sensor A (Throttle Position Sensor D) Circuit Low Voltage
- DTC P2135: TP Sensor A/B Voltage Incorrect Correlation
READ NEXT:
DTC P0122: TP Sensor A Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HD
DTC P1658: ETCS Control Relay ON
Malfunction
NOTE: Before you troubleshoot. record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Do the ETCS TEST in the
DTC P1683: Throttle Valve Default Position
Spring Performance Problem
CAUTION
Do not insert your fingers into the installed throttle
body when you turn the ignition switch ON (II) or
while the ignition switch is ON (II). If you do, you
will seriously injure your fingers
SEE MORE:
Installing a Child Seat with LATCH
Your vehicle is equipped with
LATCH (Lower Anchors and
Tethers for CHildren) at the rear
seats to secure a child seat in any
seating position: one in each outer
seating position, or one in the center.
The five lower anchors are located
between the seat-back and seat
bottom, and are to
CKP Pulse Plate Replacement
1. Remove the front wheels.
2. Remove the splash shield (see step 21).
3. Remove the drive belt.
4. Remove the cylinder head cover.
5. Set the No.1 piston at top dead center (TDC). The
punch mark on the variable valve timing control
(VTC) actuator and the punch mark on the exhaust
camshaft sproc
© 2016-2026 Copyright www.hcrv.net
