Honda CR-V: Wipers/Washers

Component Location Index

Honda CR-V. Wipers/Washers

Honda CR-V. Wipers/Washers

Honda CR-V. Wipers/Washers

Honda CR-V. Wipers/Washers

Circuit Diagram - Windshield

Honda CR-V. Wipers/Washers

Circuit Diagram - Rear Window

Honda CR-V. Wipers/Washers

READ NEXT:

 DTC Troubleshooting

DTC B1028: Rear Window Wiper Motor (As) Signal Error NOTE: If you are troubleshooting multiple DTCs, be sure to follow the instructions in B-CAN System Diagnosis Test Mode A. 1. Clear the DTCs with th

 MICU Input Test

1. Before testing, troubleshoot the B-CAN System Diagnosis Test Mode A, and check the No.8 (10 A), No. 10 (7.5 A), and No. 38 (30 A) fuses in the under-dash fuse/relay box. 2. Disconnect under-dash

 Wiper/Washer Switch Test/Replacement

1. Remove the steering column covers. 2. Disconnect the dashboard wire harness 8P connector (A) from the wiper/washer switch (B). 3. Remove the two screws, then slide out the wiper/ washer switch.

SEE MORE:

 Brake Pedal Position Switch Signal Circuit Troubleshooting

1. Turn the ignition switch ON (II). 2. Check the BRAKE SWITCH in the DATA LIST with the HDS. Does it indicate OFF? YES-Go to step 3. NO-Inspect the brake pedal position switch. 3. Press the brake pedal, and check the BRAKE SWITCH in the DATA LIST with the HDS. Does it change to ON? YES-The bra

 DTC 32-8x ("x" can be 0 thru 9 or A thru F): Short to Power in Front Passenger's Side Airbag Inflator

Special Tools Required SRS inflator simulator 07SAZ-TB4011A SRS simulator lead L 070AZ-SNAA300 NOTE: Before doing this troubleshooting procedure, review SRS Precautions and Procedures. 1. Erase the DTC memory. 2. Turn the ignition switch ON (II), and check that the SRS indicator comes on for a

© 2016-2025 Copyright www.hcrv.net