Honda CR-V: Exterior Lights
Honda CR-V (2006–2011) Service Manual / Body Electrical / Exterior Lights
Component Location Index
- DAYTIME RUNNING LIGHTS CIRCUIT
- HEADLIGHTS
- FRONT SIDE MARKER/PARKING/ TURN SIGNAL LIGHTS
- HIGH MOUNT BRAKE LIGHT
- LICENSE PLATE LIGHT
- TAILLIGHT and BRAKE LIGHT
- REAR TURN SIGNAL LIGHT
- BACK-UP LIGHT
- LIGHTS-ON INDICATOR
- HIGH BEAM INDICATOR
- DRL INDICATOR
- COMBINATION LIGHT SWITCH
- BRAKE PEDAL POSITION SWITCH
READ NEXT:
System Description
Headlights System Description
The headlight system is composed of the MICU, the headlight and
dimmer/flash-to-pass switches (inside the
combination light switch), the left and right headlights, and t
DTC Troubleshooting
DTC B1078: Daytime Running Lights Signal
Error (Canada)
DTC B1079: Daytime Running Lights Signal
Error (USA)
NOTE: If you are troubleshooting multiple DTCs, be
sure to follow the instructions in B-CAN
MICU Input Test
NOTE:
The MICU turns on the headlights (high beams) in a dim mode for the
daytime running lights under the following
conditions:
The ignition switch is ON (II)
The headlight switch is OFF
T
SEE MORE:
Receiver/Dryer Desiccant
Replacement
NOTE: Install the receiver/dryer as quickly as possible
to prevent the system from absorbing moisture from
the air.
1. Remove the A/C condenser.
2. Remove the cap (A) from the bottom of the A/C
condenser. Remove the O-ring (B) and the
desiccant (C).
3. Install the receiver/dryer in the reverse or
DTC P0122: TP Sensor A Circuit Low Voltage
NOTE: Before you troubleshoot, record all freeze data and any on-board
snapshot, and review the general troubleshooting information.
1. Turn the ignition switch ON (II).
2. Clear the DTC with the HDS.
3. Check TP SENSOR A in the DATA LIST with the
HDS.
Is there about 0.3 V or less?
YES-Go to ste
© 2016-2026 Copyright www.hcrv.net
