Honda CR-V manuals

Honda CR-V: Steering Gearbox

Honda CR-V (2006–2011) Service Manual / Steering / Steering Gearbox

READ NEXT:

 Steering Gearbox Removal

Special Tools Required Ball joint remover, 28 mm 07MAC-SL0A202 Note these items during removal: Using solvent and a brush, wash any oil and dirt off the valve body unit, it's lines, and the end of

 Steering Gearbox Overhaul

Exploded View Special Tools Required Cylinder end seal remover attachment 070AF-S7S0100 Valve seal ring sizing tool 07NAG-SR3090A Sleeve seal ring guide 07YAG-S2X0100 Sleeve seal ring sizing t

 Steering Gearbox Installation

NOTE: The illustrations show 2WD. 1. Before installing the steering gearbox, make sure that no power steering fluid is on the mating surface of the steering gearbox and the front subframe. To prevent

SEE MORE:

 Engine Coolant

Adding Engine Coolant If the coolant level in the reserve tank is at or below the MIN line, add coolant to bring it up to the MAX line. Inspect the cooling system for leaks. Always use Honda Long-life Antifreeze/ Coolant Type 2. This coolant is pre-mixed with 50 percent antifreeze and

 Stabilizer

Stabilizer Link Removal/Installation 1. Raise the front of the vehicle, and support it with safety stands in the proper locations. 2. Remove the front wheel. 3. Remove the flange nuts while holding the respective joint pin (A) with a hex wrench (B), then remove the stabilizer link (C). 4. Inst

© 2016-2025 Copyright www.hcrv.net